Unwrap the Skådis Board:

1. Remove all packaging from the IKEA Skådis board and ensure all parts are accounted for.

Insert the Feet of the Skådis board:

• Attach the feet of the Skådis board to the holes on the bottom row on the left and right sides. The feets need to be at the top of those holes.
  
  
  
   

Insert the Hooks (Crazy Glue is optional):

• Once you have finished assembling the Skådis board, you can begin assembling the 8 holders.​

  • Sort out the hooks and the pins from the bag containing them.​

    • You should have 15 hooks (plus 2 or 3 extra ones that may be a different color, included in case of breakage).​

  •  Push the hooks in on the top backside holes (the bigger holes) so the hook part is facing down. ​(Like this ┓)

    • You should be pushing in a 45 degree upward angle and the hook should be perpendicular to the holder piece.​

Attach the Holders:

• Place the 8 holders on the Skådis board following the guide on the other page.

• At this stage, ignore the pins and any parts that attach to the back of the holders.

  • Do not try to attach the holders with the bottom pins in because it will likely break or damage the hooks. The fit is made to be very tight so it can be durable and sturdy.​

Double-Check Placement:

• Carefully verify that all holders are positioned correctly according to the guide.

• Ensure nothing is out of place before proceeding.

Add the Back Pieces:

• Secure the back pieces to the holders.

• Test fit all Vitruvian accessories to confirm proper alignment and functionality.​

Insert the Pins (Proceed with Caution):

• Once you are 100% satisfied with the setup, insert the pins as directed in the images bellow.

  • Identify the specific holes on the holders where the small part of the pins need to be inserted. These holes are designed to align with the Skadis pegboard openings.

    • Use the image below to help you know where to push them and how to push them.​​

      • Basically you start with the position of the first image. Once the small part reaches the hole, you press down and upwards so the bigger part of the pin finishes straight and not angled like at the start position (look at the end position on the second image for reference).
        
        
        
        
        
        
        
        
        
        
         

    • It should be tight on the upper part of the skadis board opening (so that it counters the force of the hooks).​

  • Be aware: The pins are designed to be permanent and cannot be removed once fully inserted.

    • I made them longer so if you really need to remove the hangers, you can pull them with plyers (we also gave you 6-8 extra ones in case they break while you remove them).​​

• Start by pushing them in with your hands. For the final push, use a tool like a plastic or rubber-handled screwdriver to avoid damaging the board or pins.​

Mount the Ikea Skådis Board

• Choose a location and leave (at least): 3.75 in on the side of the long bar (for the long bar), 5.25 in from the Ceiling (for the short bar), and 49 in from the floor for the squat belt.

• Mount the wall mount and Screw the 2 top screws to hold the board on the wall.

Enjoy Your Setup:

• Your Skådis board is now ready for use. Enjoy the optimized organization and functionality during your training or activities!